DXF file And there is no relation with the current (Page 69 / 76) RDWorks V8 Laser Engraving Cutting Software User Manual

Laser Engraving Cutting Software User Manual----RDCAM V8.0

DXF file. And there is no relation with the current layer process method which no matter cutting

or scanning, primitives in graphics always output as dot primitive.

The dotting movement speed is layer speed; the dotting power is the maximum power of layer

laser.

【Laser Enable】

When the machine is equipped with two-way laser, usually the two-way will output at the same

time. But the user can set “laser enable”, making one way no output.

【The joint IO output 】

All the way and the layer associated IO output, obligate function.

【Enable sew compensation】: Use seam width compensation can compensation which caused by

laser cutting seam size of the graphics and graphic deviation of actual cutting out, seam width

compensation applies only to closed graphics.

【Sew Direction】: According to the actual need to set up, such as cut a round, if you want to keep

the circle is cut off, you should set the direction of compensation to outward, If want to keep the

hole, should set the direction of compensation to inward.

【Sew width】: The sew width of laser cutting.

69 / 76